Introduction
An amalgam restoration is built in a fixed clinical sequence: isolation, liner or base, matrix and wedge, trituration, insertion and condensation, carving, burnishing, occlusal check, and finishing and polishing after the material has set. Each step decides the marginal seal, contour, contact and lifespan of the filling. The matrix is what turns a cavity with a missing proximal wall into one that can be filled.
Prerequisites: cavity features and isolation for amalgam
Only the points that matter for technique are recalled here.
- Butt-joint margin (about 90° cavosurface angle) with no occlusal bevel, so the amalgam edge is never thin and brittle; amalgam thickness of about 1.5–2 mm.
- Retention from occlusally convergent walls, undercuts and grooves; pins or slots in large, complex restorations.
- Unsupported gingival enamel is removed with a gingival margin trimmer.
- A dry field is essential (rubber dam, or cotton rolls with suction). Moisture contamination of zinc-containing alloys during condensation causes delayed (secondary) expansion, and saliva weakens the mass.
- The liner or base is placed according to pulp depth before the matrix (see the topic on liners).