Introduction
Warm (thermoplastic) gutta-percha techniques soften the gutta-percha so that pressure carries it into canal irregularities, lateral canals and isthmuses. They aim at a three-dimensional fill that cold techniques reproduce less well. This topic covers the principle, warm vertical condensation, the continuous wave technique, other thermoplastic methods, and carrier-based obturation with the Thermafil system.
Principle: gutta-percha and heat
- Cones contain roughly 20% gutta-percha, about 60 to 75% zinc oxide, and the rest radiopacifiers (heavy metal sulfates), waxes and resins.
- Cones are in the beta phase. On heating, beta changes to alpha at about 42 to 49 °C and alpha to amorphous at about 53 to 59 °C. Heated gutta-percha shrinks as it cools, so vertical pressure must be held during cooling.
- Thermal safety: a rise of more than about 10 °C on the external root surface risks injury to the periodontal ligament and bone. Use controlled heat sources and apply heat briefly.
- A sealer is always used; check that the chosen sealer tolerates heat (some calcium-silicate sealers have heat-tolerant versions).
- Prerequisites: a continuously tapering preparation with an apical stop, a dry canal, and pluggers fitted beforehand.