Dental Materials · MU Plovdiv

32. Soldering.

Inside: 7 sections · 1 table · 5 min

Essay 32 of 85 in the MU Plovdiv syllabus for Dental Materials (Dental Medicine, Year 1). The free AceMed note covers it in 7 sections, about 676 words (5 min of reading).

In this note

  1. Introduction
  2. Definitions and terms
  3. Requirements of a solder
  4. Types and composition of solders
  5. Flux and antiflux
  6. Technique: investment soldering and free-hand soldering
  7. Soldering defects, advantages and disadvantages

Introduction

Soldering joins metal parts with a filler metal (the solder) whose melting range lies below the solidus of the parts to be joined. The parts themselves are not melted: the molten solder wets them and bonds to them by surface alloying and diffusion. In dentistry it joins units of fixed partial dentures, orthodontic wires and attachments, and is used for repairs.

Definitions and terms

  • Soldering versus brazing: by the 450 °C (840 °F) convention, filler metals that melt above 450 °C give brazing. Most dental 'soldering' is therefore technically brazing. The relevant standard is ISO 9333 (brazing materials).
  • Welding: the parent metals themselves melt and fuse, with or without a filler. Methods include laser, TIG or plasma, and electric spot welding of orthodontic bands.
  • Joint terms: solder, parent (substrate) metal, gap, flux and antiflux.

The bond forms in three ways: wetting, shown by a low contact angle; capillary flow of the solder into the gap; and diffusion and alloying at the interface.

Continue reading free

The whole note, all 7 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.