Dental Materials · MU Plovdiv

5. Surface phenomena and adhesion to tooth structure. Adsorption, absorption and sorption. Wetting, capillary penetration.

Inside: 7 sections · 1 table · 8 min

Essay 5 of 85 in the MU Plovdiv syllabus for Dental Materials (Dental Medicine, Year 1). The free AceMed note covers it in 7 sections, about 1,008 words (8 min of reading).

In this note

  1. Introduction
  2. Surface energy and surface tension
  3. Adhesion: definitions and mechanisms (classification)
  4. Wetting and contact angle
  5. Capillary penetration
  6. Adsorption, absorption and sorption
  7. Adhesion to enamel and dentin

Introduction

Surface phenomena happen at the boundary (interface) between two phases. They decide whether a fluid material spreads over enamel or dentin, gets into it and stays bonded there in a wet mouth. This makes them the physical basis of adhesive dentistry.

Surface energy and surface tension

Atoms at a surface have unbalanced attractive forces, so they carry more energy than atoms in the bulk. In solids this is called surface energy (mJ/m²); in liquids it is called surface tension (mN/m). The two units are equivalent.

  • Water has a surface tension of 72.8 mN/m at 20 °C. Surface tension falls as temperature rises and when surfactants are added.
  • High-energy surfaces: metals, ceramics and clean or acid-etched enamel. Low-energy surfaces: polymers such as PTFE and silicones.
  • Contamination by saliva, the pellicle, oil or debris lowers the surface energy of the tooth. A clean surface is therefore the first requirement for bonding.

Adhesion: definitions and mechanisms (classification)

Adhesion is the attraction between unlike molecules at an interface; cohesion is the attraction between like molecules. The material that sticks is the adhesive, the surface it sticks to is the adherend (substrate), and the boundary between them is the interface.

Adhesion is classified by mechanism:

  • Mechanical: macro-retention (undercuts, grooves) and micromechanical retention (resin tags in etched enamel, the hybrid layer in dentin).
  • Chemical, through primary bonds: carboxyl groups of polyacrylic acid in polycarboxylate and glass-ionomer cements bond to calcium in hydroxyapatite; functional monomers such as 10-MDP also bond to calcium; silane couples resin to silica-based ceramics.
  • Physical, through secondary forces (van der Waals forces, hydrogen bonds). These are weak.
  • Diffusion (interdiffusion), as when resin infiltrates the collagen network.

Clinical bonds usually combine several mechanisms. Good adhesion needs a clean, high-energy adherend; an adhesive that wets the surface (low contact angle); low viscosity; close molecular contact; setting without excessive shrinkage stress; stability in water; and compatible thermal expansion.

Failures are adhesive (at the interface), cohesive (within the adhesive or the substrate) or mixed. Bond strength is tested in shear, tension or microtension (ISO/TS 11405, testing of adhesion to tooth structure).

Continue reading free

The whole note, all 7 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.