Introduction
Thermoplastic impression materials soften on heating and harden on cooling by a purely physical, reversible change; no chemical reaction takes place. They are rigid when cold and so record no undercuts. The group includes impression compound, gutta-percha and impression (corrective and registration) waxes.
General characteristics of thermoplastic materials
In the classification they are rigid and reversibly (thermally) setting. This separates them from rigid, chemically setting materials (plaster, zinc oxide–eugenol, self-curing resins, the previous topic) and from the elastic materials (the following topics). Agar is also thermally reversible, but it is elastic.
- Low thermal conductivity: they soften and cool slowly, the outside before the inside.
- High coefficient of thermal expansion: they contract as they cool from mouth to room temperature.
- Stress release: stress built in during cooling is released later and causes distortion, so the cast should be poured promptly.
- They can be re-softened, so in principle they are reusable, but reuse between patients is not hygienic.
- Flow: it must be low at mouth temperature and high just above it, so that the material is plastic when inserted and rigid when removed.