Introduction
Rotary instruments remove tooth tissue and restorative materials in two ways. Bladed burs (steel, tungsten carbide) cut by shearing off chips. Abrasive instruments (diamond, stones) remove material by abrasion. How efficiently they work depends on the design and material of the instrument, the speed, the load, the substrate and the cooling.
Classification of rotary instruments
By mode of action: bladed (cutting) instruments, i.e. burs of carbon steel or tungsten carbide, and abrasive instruments, i.e. diamond instruments, abrasive stones, discs and wheels.
By speed range:
- low speed: below 12,000 rpm;
- medium (intermediate) speed: 12,000–200,000 rpm;
- high (ultra-high) speed: above 200,000 rpm.
Drive units: the air turbine has a very high free-running speed but low torque, and its speed falls under load. The electric micromotor keeps a steady torque under load, and with a speed-increasing contra-angle it reaches the high-speed range.
By shank (handpiece fit, ISO 1797):
- straight handpiece (HP): shank diameter 2.35 mm;
- contra-angle latch type (RA/CA): 2.35 mm;
- friction grip (FG) for the turbine: 1.6 mm.
Numbering follows the ISO 6360 number coding system, in which the last three digits give the head diameter in tenths of a millimetre (010 means 1.0 mm). The traditional US numbers are still used, for example round ¼–8, inverted cone 33½ and up, straight fissure 56–58, tapered fissure 169–171, and pear 330/245.