Preclinical Prosthetic Dentistry · MU Plovdiv

93. Modelling, investing and finishing of full dentures.

Inside: 8 sections · 1 table · 7 min

Essay 93 of 96 in the MU Plovdiv syllabus for Preclinical Prosthetic Dentistry (Dental Medicine, Year 1). The free AceMed note covers it in 8 sections, about 972 words (7 min of reading).

In this note

  1. Introduction
  2. Final wax modelling (wax-up) of the trial denture
  3. Flask and gypsum
  4. Investing (flasking) methods
  5. Wax elimination (boil-out) and separation
  6. Packing and polymerisation of heat-cured PMMA
  7. Deflasking, laboratory remount, finishing and polishing
  8. Common processing faults

Introduction

After a successful wax try-in, the wax complete denture is turned into acrylic in the laboratory. The steps are final wax modelling, investing (flasking), wax elimination, packing and polymerisation of heat-cured PMMA, deflasking, then finishing and polishing. Each step can add errors to the fit, the occlusion or the vertical dimension, so the technique has to be exact.

Final wax modelling (wax-up) of the trial denture

  • Material and tools: baseplate (modelling) wax (casting and baseplate waxes are covered by ISO 15854); wax knife, Le Cron carver, spatula, Bunsen burner or a fine (Hanau-type) torch.
  • Seal the wax base to the cast all round. The borders must fill the sulcus depth and width recorded by the impression and be rounded and thick, not knife-edged.
  • Gingival contouring: the wax margin follows the cervical outline of each tooth so the anatomical crown shows. Give a festoon shape, convex interdental papillae, and root eminences (the canine eminence is the most prominent) with slight hollows between the roots.
  • Polished surfaces: buccal and lingual surfaces slightly concave, so the cheeks and tongue help to hold the denture. Keep the palatal thickness uniform (commonly about 2 mm). The palatal rugae may be copied.
  • Posterior palatal seal (post-dam): if not done earlier, scrape it into the upper master cast along the vibrating line, between the hamular (pterygomaxillary) notches.
  • Smooth the wax by flaming it lightly and polishing with a damp cloth. Stippling ("orange peel") is optional for a natural look.
  • Remove all wax from the ridge-lap surfaces of acrylic teeth so the resin can bond. Porcelain teeth are held only mechanically: pins on anterior teeth, diatoric holes on posterior teeth.

Continue reading free

The whole note, all 8 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.