Introduction
The marginal fit of a full crown depends first on an accurate final impression of the prepared tooth and its finish line. This note follows the crown from impression through laboratory work, try-in (adjustment) and fixation, to its removal when needed, using the full cast metal crown as the model protocol.
Requirements of the impression and gingival displacement
- Exact reproduction of the prepared tooth and the whole finish line, plus a little unprepared tooth beyond it, and of the adjacent teeth and contacts.
- No bubbles, tears or distortion at the margin; dimensional stability until the cast is poured.
- Trays: rigid stock trays, or custom trays with a uniform 2–3 mm spacer for monophase or polyether techniques; tray adhesive is used, and the tray must not touch the prepared tooth.
Gingival displacement (retraction) opens the sulcus so the material can record the margin. Moisture and bleeding must be controlled.
- Mechanical: retraction cord, single- or double-cord technique (the thin lower cord stays in the sulcus, the upper cord is removed just before the wash is injected).
- Chemomechanical: cords impregnated with aluminium chloride or ferric sulfate. Epinephrine cords should be avoided in cardiovascular patients. Rinse well, because residual haemostatic agents may impair setting.
- Retraction pastes.
- Surgical: electrosurgery, laser, rotary curettage.