Prosthetic Dentistry – Part II · MU Plovdiv

5. Clinical procedures for fabrication of a plastic crown and an all- ceramic crown. Other types of crowns without metal coping – Specificity

Inside: 8 sections · 1 table · 8 min

Essay 20 of 30 in the MU Plovdiv syllabus for Prosthetic Dentistry – Part II (Dental Medicine, Year 3). The free AceMed note covers it in 8 sections, about 881 words (8 min of reading).

In this note

  1. Introduction
  2. Plastic (resin) crowns: types, indications, limitations
  3. Clinical and laboratory steps for a plastic crown
  4. All-ceramic materials: classification and properties
  5. Indications, contraindications and preparation for all-ceramic crowns
  6. Clinical steps for an all-ceramic crown (in order)
  7. Other crowns without a metal coping: specificity
  8. Errors and complications

Introduction

These are crowns with no metal framework. Plastic (resin) crowns are mainly provisional today. All-ceramic crowns are definitive restorations chosen for esthetics and biocompatibility. Their success depends on choosing the material, the preparation design and the cementation method together.

Plastic (resin) crowns: types, indications, limitations

Materials: heat-cured or self-cured PMMA, bis-acryl composite, laboratory (indirect) composite, and CAD/CAM milled PMMA or composite blocks.

Indications:

  • Provisional crowns: protect the pulp and tooth, keep the tooth in position, protect the gingiva, test esthetics and occlusion, and serve as a diagnostic step for changes in the vertical dimension of occlusion (VDO).
  • Interim crowns in young patients until a definitive crown is possible.
  • Long-term provisionals during periodontal, endodontic or implant treatment.

Limitations as definitive crowns: low strength, wear, water sorption, discoloration, polymerisation shrinkage, plaque retention, gingival irritation and possible allergy to residual monomer. Long-term use is contraindicated in bruxism, deep bite and short clinical crowns.

Clinical and laboratory steps for a plastic crown

Preparation: an all-round shoulder of about 1 mm with a rounded internal angle, facial reduction of about 1–1.5 mm, and incisal or occlusal reduction of about 1.5–2 mm.

Direct provisional technique (chairside):

  1. Take a pre-operative impression or make a vacuum-formed matrix.
  2. Prepare the tooth.
  3. Load the matrix with resin and seat it.
  4. Remove it at the rubbery stage.
  5. Trim, adjust the occlusion and polish.
  6. Cement with temporary cement.

Indirect (laboratory) technique:

  1. Impression and cast.
  2. Wax-up.
  3. Flasking.
  4. Wax elimination, then application of a separating medium.
  5. Packing of PMMA dough.
  6. Heat polymerisation.
  7. Deflasking, finishing and polishing. CAD/CAM milling can replace the flasking-to-polymerisation steps. Then follow try-in, adjustment and cementation.

Points to stress: polished, well-adapted margins; correct contours for gingival health; contacts and occlusion checked.

Continue reading free

The whole note, all 8 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.