Prosthetic Dentistry – Part II · MU Plovdiv

8. Impression materials and methods in fixed prosthetics – Characteristics, types, selection, disadvantages. Adhesives

Inside: 8 sections · 1 table · 8 min

Essay 8 of 30 in the MU Plovdiv syllabus for Prosthetic Dentistry – Part II (Dental Medicine, Year 3). The free AceMed note covers it in 8 sections, about 1,092 words (8 min of reading).

In this note

  1. Introduction
  2. Requirements and classification
  3. Elastomeric impression materials — characteristics
  4. Other materials in fixed prosthodontics and their limits
  5. Trays and tray adhesives
  6. Impression techniques
  7. Clinical procedure, evaluation, disinfection and pouring
  8. Selection, disadvantages and typical errors

Introduction

A definitive impression in fixed prosthodontics must record the prepared teeth (especially the finish line and a little unprepared tooth beyond it), the adjacent teeth and the soft tissues with micrometre accuracy, and it must stay dimensionally stable until the cast is poured. This is achieved mainly with elastomers or, increasingly, with intraoral scanners. "Adhesives" here means tray adhesives, not luting cements or bonding agents.

Requirements and classification

Ideal properties: accuracy and fine detail, elastic recovery, dimensional stability, tear strength, wettability (hydrophilicity), suitable working and setting time, compatibility with die materials, biocompatibility, pleasant taste and smell, ability to be disinfected, and reasonable cost.

  • By behaviour after setting: rigid (non-elastic) materials are impression plaster, impression compound, zinc oxide–eugenol paste and waxes. Elastic materials are hydrocolloids (reversible agar, irreversible alginate) and elastomers (polysulfide, condensation silicone, addition silicone or vinyl polysiloxane, polyether, vinyl polyether silicone hybrid).
  • By setting: chemical (irreversible) or physical (reversible, thermoplastic).
  • ISO 4823 consistency types: Type 0 putty, Type 1 heavy-bodied, Type 2 medium-bodied (monophase), Type 3 light-bodied. Types 1–3 must reproduce a 20 µm line. ADA specification No. 19 is the corresponding American standard for elastomers.

Continue reading free

The whole note, all 8 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.