Introduction
Cold working means changing the shape of a metal or alloy permanently (plastic deformation) below its recrystallization temperature, usually at room temperature. It makes the metal harder and stronger (strain hardening or work hardening) but costs ductility. It is how wrought dental products are made, and it also happens whenever metal is bent, burnished or adjusted in the clinic or laboratory.
Definitions and classification of metal working
- Elastic deformation disappears when the load is removed; plastic deformation is permanent. The proportional (elastic) limit and the yield strength mark the point where permanent deformation starts.
- By working temperature: cold working is done below the recrystallization temperature, so the hardening remains. Hot working is done above it; recrystallization goes on during deformation, so no lasting hardening results.
- A cast alloy is used in the shape it solidified in. A wrought alloy is first cast as an ingot and then worked mechanically into its final form.
- Ductility is the ability to be drawn into wire under tension; malleability is the ability to be hammered or rolled into sheet under compression. Gold is the most ductile and malleable metal, silver comes next. Ductility is measured as percentage elongation or reduction in area.