Introduction
In the lost-wax technique the wax pattern is fixed to a sprue former, placed in a casting ring and surrounded by investment, a heat-resistant (refractory) mould material. When the wax is burnt out it leaves a mould of exact size, into which molten alloy is cast. Spruing controls how the metal flows in, and the expansion of the investment makes up for the shrinkage of the alloy. This topic covers sprue design and the types of investment.
The lost-wax sequence and the purpose of the sprue
The steps follow in a fixed order:
- wax pattern, then the sprue former attached to it;
- crucible former (sprue base) and casting ring with liner;
- investing and setting;
- wax elimination (burnout) and heating of the mould;
- casting (its methods belong to the previous topic).
The sprue is the channel through which melted wax and gases leave the mould and through which molten alloy enters it. It also feeds the casting while the metal solidifies.
- Clean the pattern and coat it with a surfactant (wetting agent, 'debubblizer') before investing. This reduces air bubbles, which would appear as nodules on the casting.
- Invest the pattern promptly. Stresses stored in the wax are released with time and the pattern distorts.