Dental Materials · MU Plovdiv

28. Melting and casting. Methods of casting.

Inside: 7 sections · 1 table · 7 min

Essay 28 of 85 in the MU Plovdiv syllabus for Dental Materials (Dental Medicine, Year 1). The free AceMed note covers it in 7 sections, about 886 words (7 min of reading).

In this note

  1. Introduction
  2. The lost-wax process: overview and requirements
  3. Burnout and mould temperature
  4. Melting the alloy
  5. Methods of casting: casting machines
  6. Cooling, divesting and cleaning
  7. Faults caused by melting and casting

Introduction

Casting means melting an alloy and forcing it into a refractory mould formed around a wax pattern. Dentistry uses the lost-wax technique, introduced to dentistry by Taggart in 1907, for inlays, onlays, crowns, bridge frameworks, metal–ceramic copings and partial-denture frameworks. This topic covers melting the alloy, the force that fills the mould, the casting machines and the handling of the casting afterwards.

The lost-wax process: overview and requirements

Sequence: wax pattern, sprue, investing, burnout (wax elimination), melting, casting, cooling, divesting, cleaning (pickling or blasting), finishing. Spruing and investing are the subject of the next topic.

  • A good casting has an accurate fit, complete margins, a smooth surface, no porosity and preserved alloy properties.
  • Casting shrinkage of gold alloys is about 1.25–1.65%. It happens in three stages: liquid contraction (fed from the button), contraction on solidification, and thermal contraction of the solid to room temperature. Investment expansion compensates for it.
  • Why force is needed: the surface tension of the molten alloy and the air in the mould (back pressure) stop gravity alone from filling a fine mould.

Continue reading free

The whole note, all 7 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.