Dental Materials · MU Plovdiv

67. Polyether.

Inside: 7 sections · 1 table · 5 min

Essay 67 of 85 in the MU Plovdiv syllabus for Dental Materials (Dental Medicine, Year 1). The free AceMed note covers it in 7 sections, about 549 words (5 min of reading).

In this note

  1. Introduction
  2. Classification and standard
  3. Composition
  4. Setting reaction
  5. Properties
  6. Manipulation and clinical use
  7. Advantages and disadvantages

Introduction

Polyethers are elastic, non-aqueous (elastomeric) impression materials. They set by cationic ring-opening polymerisation without a by-product. They are hydrophilic, accurate and very stiff, and are used for fixed prosthodontic and implant impressions.

Classification and standard

  • By chemistry, the elastomeric impression materials are polysulfide, condensation silicone, addition silicone and polyether.
  • The standard is ISO 4823 (older ADA No. 19). It defines viscosity classes: Type 0 putty, Type 1 heavy-bodied, Type 2 medium-bodied (monophase) and Type 3 light-bodied.
  • Polyether was first supplied as a single medium-bodied (monophase) material; light and heavy versions followed.
  • Setting is a chemical, irreversible reaction, and the set material is elastic.

Composition

  • Base paste: a low-molecular-weight polyether (a copolymer of ethylene oxide and tetrahydrofuran) with terminal aziridine (ethylene imine) rings; a filler (colloidal silica); and a plasticiser (glycol ether or phthalate type).
  • Catalyst (accelerator) paste: an aromatic (alkyl-aromatic) sulfonate ester as initiator, with filler and plasticiser.
  • Mixing: base and catalyst are combined in the manufacturer's ratio, with much more base than catalyst. This is done by hand on a pad until streak-free, or, more usually now, by dynamic mechanical mixing or static auto-mixing cartridges.

Continue reading free

The whole note, all 7 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.