Introduction
An impression is only as accurate as its handling. Most failed casts come from avoidable errors at five stages: storing the material, mixing, taking the impression, storing it and pouring it. A good exam answer links every fault to its cause and to the step that prevents it.
Why errors matter: the sources of inaccuracy
An accurate impression needs detail reproduction, dimensional stability, enough tear strength and elastic recovery, and compatibility with gypsum. Several things change the dimensions of any impression:
- polymerization shrinkage;
- loss of by-products: water from polysulfide, ethanol from condensation silicone;
- thermal contraction as the impression cools from mouth temperature (about 37 °C) to room temperature;
- water loss or uptake, especially in hydrocolloids and polyether;
- incomplete elastic recovery after deformation over undercuts;
- release of stress, mainly in non-elastic thermoplastic materials.
Storing the materials before use
- Alginate powder: keep it in a tightly closed container, cool and dry, and close the lid straight after dispensing. Moisture and heat break the alginate down, so it sets too fast or poorly and gives a weaker gel. Shake (fluff) the can before dispensing so the bulk density is even. Avoid breathing the dust, because the filler is diatomaceous earth; dust-free alginates exist.
- Agar: the tubes pass through the conditioning unit: liquefy in boiling water, store at about 63–66 °C, temper at about 46 °C before use in a water-cooled tray. Repeated reboiling or poor conditioning gives a grainy material that is too stiff or too runny.
- Elastomers: store at room temperature away from heat, respect the expiry date, and recap each tube with its own cap, because swapped caps contaminate base with catalyst. Polyether absorbs moisture, so keep it dry. Heat and humidity shorten working time, polysulfide most of all, while cooling the pastes lengthens working time of addition silicone. Bleed a cartridge before fitting the mixing tip.
- Non-elastic materials: impression compound and zinc oxide–eugenol paste need no special storage but should stay away from heat. Keep impression plaster dry.