Special Oral Surgery (Local Anaesthesia and Analgesia) · MU Plovdiv

19. High-frequency electrosurgery, piezosurgery and lasers in oral surgery.

Inside: 7 sections · 1 table · 7 min

Essay 19 of 38 in the MU Plovdiv syllabus for Special Oral Surgery (Local Anaesthesia and Analgesia) (Dental Medicine, Year 3). The free AceMed note covers it in 7 sections, about 924 words (7 min of reading).

In this note

  1. Introduction
  2. High-frequency electrosurgery: principle and equipment
  3. Electrosurgery: indications, contraindications, complications
  4. Piezosurgery: principle and characteristics
  5. Piezosurgery: indications in oral surgery
  6. Lasers: physical basis and laser-tissue interaction
  7. Lasers: types, uses, advantages and safety

Introduction

Besides the scalpel and the rotary bur, oral surgery uses three energy-based ways to cut and coagulate: high-frequency current, ultrasonic (piezoelectric) vibration and laser light. Each works on a different physical principle, so each fits a different job: soft tissue with haemostasis, selective bone cutting, or work targeted by wavelength.

High-frequency electrosurgery: principle and equipment

Electrosurgery uses radiofrequency alternating current, far above 100 kHz (dental units work in the low-megahertz range). At this frequency nerves and muscles are not stimulated (no faradic effect). Heat forms inside the tissue from its electrical resistance; the electrode itself stays cold.

  • Monopolar: an active electrode plus a dispersive (passive) return plate or antenna.
  • Bipolar: current flows only between the two tips of a forceps. It is mainly used for haemostasis and gives less current spread.

Waveforms in classic dental teaching:

  • fully rectified, filtered (continuous): pure cut with little lateral heat;
  • fully rectified: cut plus some coagulation;
  • partially rectified: coagulation;
  • spark-gap (highly damped): fulguration.

The techniques are electrosection (electrotomy), electrocoagulation, fulguration and electrodesiccation. Electrodes are chosen by job: fine wire or needle for incision, loop for planing and excision, ball for coagulation. The term radiosurgery is used for high-frequency (MHz) units that cut with minimal lateral heat.

Working rules:

  • keep the field moist but not flooded, and use high-volume suction to clear the smoke plume;
  • use light, quick, pressure-free strokes and let the tissue cool for a few seconds between passes over the same spot;
  • never touch bone, periosteum, metal restorations or implants;
  • no flammable agents (alcohol, oxygen-enriched air).

Continue reading free

The whole note, all 7 sections, is free with an AceMed account. Standard adds flashcard recall, highlights and Ask AI.