Introduction
Heat sources are the devices and forms of energy used in the dental laboratory and clinic to bring materials to working temperature: to soften wax and thermoplastics, eliminate wax, melt and cast alloys, solder and weld, fire or sinter ceramics, and polymerize resins. The choice depends on the temperature needed, the alloy, the risk of contamination and how precisely the temperature can be controlled.
Classification of heat sources
By form of energy:
- Flame (combustion of a fuel gas with air or oxygen): alcohol (spirit) lamp, Bunsen burner, gas–air blowpipe torch, gas–oxygen torch. Fuels are natural gas, propane, butane and acetylene.
- Electrical: resistance heating, induction heating, and the electric arc (including the argon-shielded arc and plasma).
- Radiant or electromagnetic: laser, infrared, microwave.
- Hot media: water baths and hot air.
By purpose: wax and thermoplastics; melting and casting alloys; soldering and welding; ceramics; resins.
Flame heat sources: fuels, torches and flame zones
Air contains only about 21% oxygen, and the nitrogen absorbs heat, so a gas–air flame is cooler than a gas–oxygen flame.
- Gas–air torch: enough for conventional gold casting alloys and gold soldering, but not for high-fusing metal–ceramic or base-metal alloys.
- Gas–oxygen torch (propane or natural gas with O₂): used for metal–ceramic noble and palladium alloys.
- Oxy-acetylene: the hottest flame, about 3,100 °C, used for base-metal alloys. Drawbacks: carbon contamination of the alloy if badly adjusted, and acetylene is unstable and hazardous.
A properly adjusted torch flame has four zones:
- Mixing zone: the inner, colourless, cool part where there is no combustion.
- Combustion zone: a green-blue cone with partial combustion; it is not hot enough and is not used for melting.
- Reducing zone: dim blue, just beyond the tip of the inner cone, and the hottest part. This is the zone used to melt the alloy.
- Outer oxidizing zone: burns with air and is not used.
Adjustment: aim for short, sharply defined cones with a neutral to slightly reducing flame. Too much air or oxygen gives an oxidizing flame, causing oxidation and gas porosity. Too little gives a luminous, sooty flame that is cooler and deposits carbon.